VIEW / PRINT CATALOGUE WD6B/D3 VOLTAGE DETECTOR   Product Description Three models of WD6B/D3 live line tester are available for use between 5-12kV, 10-36kV and 50-140kV. The circuitry is housed within the slim tubular body. The sound LEDs’ on-off switch and test button are mounted on an oval plate facing the operator. When the unit is switched on, an intermittent tone will start and the LEDs will start to flash in synchronisation. The entire circuitry is verified by pressing the test button. When the test button is released, the tone and LEDs will immediately revert to an intermittent signal, which operates until the unit makes contact with a live source or is switched off. The detector should be tested before an operation. It is also possible to verify the detector using a separate proving unit, type MD, which can be ordered separately. The WD6B/D3 live line tester must be mounted on an operating pole which is available separately. Various connection adaptors are also available; however the basic unit is designed to be mounted on the top section of a U.K. standard operating pole. The pole head type should be advised if only the detector is to be supplied. The number of pole sections to be used with the detector as a minimum will depend upon the voltage to be tested and the type of pole used. Periodically, it will be necessary to change the battery in the detector. The battery compartment is located in the bottom of the tubular body, below the label and can be released by removing the nylon screw.   Product Benefits ** Visible and audible detection ** Suitable for fitting to standard Operating Pole Sections ** Test facility ** Battery operated ** Rugged construction ** Available for 5-12kV, 10-36kV and 50-140kV Product Specification Item Code DSSB-SSE-PEE-WD6B/D3-5/12 DSSB-SSE-PEE-WD6B/D3-10/36 DSSB-SSE-PEE-WD6B/D3-50/140 Product Image   read more

VIEW / PRINT CATALOGUE CE80 Link Box Short Term Temporary Earth Kit Product Description The PBwel Link Box (Switching Point) Earthing Kits are available for a range of designs and are used whilst maintenance, electrical diversion or cable testing is undertaken. Compromising of 4 CE80 Sprung loaded insulated Bronze clamps connected by flexible Copper stranded cables. To be used for Link Box earthing whilst main earthing kit is applied. Current rating: 150A/5mins Short circuit rating: 4.9kA/1s Insulation rating: Typically 2kV/1min Conductor size:1-1 /2'' x 1/2'' nominal Product Benefits ** Simple to apply ** Supplied in a protective carrying bag ** Fully tested & type registered ** High insulation rating ** Robust construction ** Special clamp design Product Specification   Item Code DSSB-EFU-19311 Product Image     read more